Bells of Steel Hydra Flat Foot Power Rack
True 3x3, 11-gauge uprights in four heights from 72 to 110 inches, rated to 1,000 lb — and a flat foot, so no bolts.
Specs
| Total height | 72.25, 86.25, 92.25 or 110.25 in |
|---|---|
| Total depth | 56 in or 62 in |
| Total width | 47 in or 49 in |
| Upright | True 3 x 3 in (76.2 x 76.2 mm) |
| Steel thickness | 11-gauge (3.0 mm) |
| Hole size | 5/8 in (15.9 mm) |
| Hole spacing | 1 in and 2 in |
| Weight capacity | 1,000 lb (454 kg) |
| Rack pin | Custom Bells of Steel pin, included |
| Coating | Powder coat |
| Warranty | Limited lifetime |
These figures are copied from Bells of Steel’s own published specs and were last checked on 2026-08-31. Manufacturers revise products without notice, and variants differ. Confirm anything your decision depends on with Bells of Steel before you buy.
Choose this one if
- You cannot or will not bolt a rack into your floor
- You want to pick a height that actually fits your ceiling
- You want true 3x3 uprights and 1-inch spacing in the bench zone
The detail
Four heights is the reason to look at this rack: 72.25, 86.25, 92.25 and 110.25 inches. Nearly every rack comes in one height and you make it work. A 72-inch option fits a basement where an 86-inch rack cannot stand; 110 inches is for a garage with the roof structure exposed and rope climbs in mind. That is a genuine range rather than two token options.
The flat foot is the other headline. A conventional four-post cage is stabilised by being bolted down or by its own footprint; flat feet extend the base forward so the rack resists tipping without anchors. If you rent, have a finished floor, or simply do not want to drill concrete, this is the design that solves it.
True 3x3 uprights with 5/8-inch holes at 11-gauge is a serious specification — "true" being the word that matters, since some racks measure 3x3 on the outside of a smaller tube. Combined with a 1,000 lb capacity, this is above the Bells of Steel residential rack's 700 lb and level with the best home racks.
Dual hole spacing — 1 inch and 2 inch — is what makes a rack good to bench in. Two-inch spacing everywhere is fine for squats and maddening for a bench, where the right J-cup height is often between two holes. Tighter spacing in the bench zone fixes that.
Depth is 56 or 62 inches and width 47 or 49, which is a big rack in any configuration. Budget the floor before you budget the money.
Note the hole size: 5/8 inch, not the 1-inch Manticore standard. Bells of Steel runs two 3x3 lines with different holes, and attachments — including the lat pulldown — are sold per line. Get this right at order time.