Cry Once
Disclosure Some links here are affiliate links. If you buy through one, we may earn a commission at no extra cost to you. Full disclosure.
Bells of Steel / Storage

Bells of Steel 3 Barbell Wall Rack

Two 5.5 lb arms that hold three bars horizontally on a wall, with HDPE-lined cups so nothing touches bare steel.

View at Bells of Steel

Specs

Contents2 arms
Weight5.50 lb
Length16.12 in (410 mm)
Width2.5 in (64 mm)
Height5.5 in (140 mm)
Cup liningHDPE
CoatingPowder coat
Warranty1 year

These figures are copied from Bells of Steel’s own published specs and were last checked on 2026-08-31. Manufacturers revise products without notice, and variants differ. Confirm anything your decision depends on with Bells of Steel before you buy.

Choose this one if

  • You own three or more bars and no rack real estate to spare
  • Your ceiling is too low to stand bars on end
  • You want the cheapest possible fix for bars on the floor

The detail

Once you own a third bar — a power bar, a Swiss bar, a trap bar — they end up in a corner, leaning against each other, getting knocked over. This solves that for about five and a half pounds of steel on a wall.

The HDPE cup lining is the detail worth paying attention to. Bar sleeves and shafts resting directly on bare steel get scratched, and a scratch through the coating is where rust starts. Plastic lining means the bar sits on something softer than itself. On a rack that will hold the same three bars for a decade, that is the difference between bars that look used and bars that are damaged.

Horizontal storage on a wall is the right answer for anyone whose ceiling rules out standing a bar on end — which is most basements. A 7-foot bar needs 7 feet of clear height plus room to lift it in. On a wall it needs about 16 inches of depth.

At 16.12 inches long the arms project that far from the wall, so plan clearance: three bars side by side sit within that depth and you do not want to walk into them. Mount them somewhere you do not turn a corner.

Compare the Titan horizontal barbell holders, which do the same job bolted to a rack upright rather than a wall. If you have rack space, use the rack; if the rack is full, use the wall.

These mount to a wall, so the wall does the work. Find studs. Two arms holding three loaded-length bars is a real load hanging off drywall anchors, and the warranty is one year on the hardware, not on your plasterboard.