Titan TITAN Series Deadlift Bar
A 90.5-inch, 200,000 PSI bar built to bend — aggressive knurl, no centre knurl, rated to 2,000 lb.
Specs
| Product weight | 20 kg (45 lb) |
|---|---|
| Shaft diameter | 28.5 mm |
| Sleeve diameter | 50 mm |
| Overall length | 90.5 in |
| Loadable sleeve length | 16.25 in |
| Sleeve to sleeve length | 55.5 in |
| Knurling | Aggressive |
| Knurling length | 17 in |
| Center knurl | None |
| Knurl marks | Single, powerlifting |
| Shaft coating | Bright zinc |
| Sleeve coating | Hard chrome |
| Sleeve assembly | Bronze bushings |
| Tensile strength | 200,000 PSI |
| Weight capacity | 2,000 lb |
| Origin | Made in the USA |
These figures are copied from Titan Fitness’s own published specs and were last checked on 2026-08-31. Manufacturers revise products without notice, and variants differ. Confirm anything your decision depends on with Titan Fitness before you buy.
Choose this one if
- You deadlift and want the bar to flex before the plates leave the floor
- You want aggressive knurl and know what that means for your hands
- You have 90.5 inches of clear space, which is longer than a standard bar
The detail
A deadlift bar is designed to bend, and that is not a defect. At 90.5 inches long — four and a half inches over a standard bar — with a 28.5 mm shaft and 200,000 PSI steel, this bar flexes noticeably under load. The practical effect is that the bar starts moving before the plates do, so you break the floor from a slightly higher hip position and the pull feels smoother. Competition deadlift bars work this way on purpose.
That same whip is exactly wrong under a squat, where you want the bar rigid across your back. This is not a bar to squat with; the Elite Series power barbell at 29 mm and 220,000 PSI is.
Aggressive knurl over 17 inches with no centre knurl is the correct deadlift specification. Long knurl means your grip lands on texture wherever you set your hands; aggressive means it does not slip when your palms are wet; no centre knurl means nothing scraping your thighs on the way up. Single powerlifting marks match the discipline.
Two thousand pounds and 200,000 PSI are both near the top of what is offered here, and made in the USA from American steel is unusual at this price.
The length is what to check before buying: 90.5 inches, with 55.5 inches between the sleeves. It will not sit in J-cups spaced for an 86-inch bar the way you expect, and it needs more clear floor than a standard bar. That is fine — you do not rack a deadlift bar — but measure your pulling space.
Bright zinc on the shaft is the weak point: the least durable common finish, and it will patina at the knurl. Bronze bushings under hard chrome sleeves give moderate, durable spin, which is all a deadlift bar needs.