Titan T-3 Series Half Rack
A 92.5-inch 2x3 half rack with Westside spacing, four plate holders and a 1,000 lb rating.
Specs
| Overall height | 92.5 in |
|---|---|
| Base dimensions | 47 x 48 in |
| Walk-in dimensions | 41 x 42 in |
| Pull-up bar max height | 89 in |
| Pull-up bar length | 42 in |
| Pull-up bar diameter | 1.25 in |
| Hole size | 11/16 in |
| Hole spacing | Westside, 6 in side holes |
| Weight plate sleeve length | 11.5 in |
| Weight plate sleeve diameter | 50 mm |
| Material | 2 x 3 in, 11-gauge steel |
| Finish | Powder-coated black |
| Weight capacity | 1,000 lb |
| Product weight | 230 lb |
These figures are copied from Titan Fitness’s own published specs and were last checked on 2026-08-31. Manufacturers revise products without notice, and variants differ. Confirm anything your decision depends on with Titan Fitness before you buy.
Choose this one if
- You want to lift outside a rack with the uprights behind you
- You want Westside hole spacing for precise bench setup
- You want four plate holders built into the rack
The detail
Westside hole spacing is the specification that separates this from Titan's other racks. Westside means tighter spacing through the bench-press zone and wider elsewhere — the pattern named after Westside Barbell, and the answer to the problem that on 2-inch spacing the right J-cup height for a bench is usually between two holes. The TITAN Series 90x36 uses 2 inches throughout; this does not.
A half rack means lifting in front of the uprights rather than inside a cage: no steel beside your elbows, room to walk out of a squat, and space for a bench or a machine that would not fit in a four-post. The 41 by 42 inch walk-in area is generous.
Four weight plate holders built in is more than a convenience. Plates on the uprights are plates you are not walking across the room for, and their mass at the base of a 230 lb rack materially improves stability — which matters on a half rack, where a loaded front is a lever.
At 1,000 lb this is rated below Titan's 3x3 TITAN Series half rack at 2,000 lb, which is the honest consequence of 2x3 rather than 3x3 uprights. A thousand pounds covers essentially every home lifter.
Height is the constraint: 92.5 inches, with the pull-up bar up to 89. That needs a genuine 8-foot ceiling with clearance, and it is nearly a foot taller than the 82-inch T-3 cage. In a basement it will not stand.
J-hooks with UHMW padding are included, which is the correct facing — plastic between your bar and the steel, not metal on metal.
The 11/16-inch holes are the T-3 pattern, so T-3 strap safeties and other 2x3 attachments fit.